KitchenAid KUWL304ESS-SS Manual Do Utilizador

WINE CELLAR USE

Normal Sounds

Your new wine cellar may make sounds that your old one didn’t 
make. Because the sounds are new to you, you might be 
concerned about them. Most of the new sounds are normal. Hard 
surfaces, such as the flooring and surrounding structures, can 
make the sounds seem louder. The following describes the kinds 
of sounds and what may be making them.

■

Your wine cellar is designed to run more efficiently to keep 
your wine at the desired temperatures and to minimize energy 
usage. The high efficiency compressor and fans may cause 
your wine cellar to run longer than your old one. You may also 
hear a pulsating or high-pitched sound from the compressor 
or fans adjusting to optimize performance.

■

Rattling noises may come from the flow of refrigerant or items 
stored inside the wine cellar.

■

As each cycle ends, you may hear a gurgling sound due to 
the refrigerant flowing in your wine cellar.

■

You may hear water running into the drain pan when the wine 
cellar is defrosting.

■

You may hear clicking sounds when the wine cellar starts or 
stops running.

Using the Controls

The control panel for the wine cellar is located on the middle 
separator (mullion) of the wine cellar. The control of the wine 
cellar has no mechanical parts or buttons. When disconnected, 
the control panel displays nothing and may be difficult to locate. 

■

The first time that the wine cellar is plugged in, the control will 
be in Cool Off mode. Cool On and Cool Off will be the only 
options that display.

■

Press COOL ON for 3 seconds to turn on the wine cellar. All 
menus and recommended temperature settings will be 
displayed.

■

The left temperature and preset touch pads control the 
temperature of the upper compartment.

■

The right temperature and preset touch pads control the 
temperature of the lower compartment.

■

Press the F/C touch pad to toggle between displaying the 
temperature in degrees Fahrenheit and degrees Celsius. The 
corresponding indicator will illuminate. 

When the wine cellar is turned On for the first time, the 
temperature defaults to the recommended setting. There are two 
adjustable temperature controls, with one for each compartment.   

■

To adjust set point temperatures, press “+” (plus) or “-” 
(minus) until the desired temperature setting is reached. 

NOTE: The set point for the wine cellar is 50°F (10°C) for both the 
upper and lower compartments. The set point range for the 
upper compartment is 42°F to 54°F (5°C to 12°C) and 42°F to 
64°F (5°C to 17°C) for the lower compartment

The control is set correctly when the wine is as cold as you like it.

NOTE: Wait at least 24 hours between adjustments for the 
product to acclimate. Recheck the temperatures before making 
further adjustments.