Aluratek APBL01FSB Manual Do Proprietário

Portable Battery Charger with LED Flashlight

  

qsg Q10319 / Q10320 / Q10321     Copyright © 2013 Aluratek, Inc.   All Rights Reserved.

The battery is not fully charged and it is highly recommended that you 

charge APBL01Fxx before you begin using it.

Note: Using APBL01Fxx “out of the box” will not harm the device. You will 

experience reduced battery life as the unit will not be fully charged.

To charge the device, connect the USB end of the cable provided to your 

PC and the charger plug to the charging jack of APBL01Fxx.  Please 

charge the battery for a minimum of (5) hours.  The Red LED will be on 

while charging. When charging is complete, the red LED will turn off.

*Original charging cable required

Charge the battery charger with 

the included Micro USB cable

On - Off button with 

power level indicators 

LED Flashlight 

*Connect your 

compatible digital device 

for charging 

5V / 1.0A

To turn the LED flashlight on or off, simply press and hold down the       

button for two seconds.

Use the original cable that came with your device or a cable with suitable 

connector. Connect the USB tip to one of the USB Output ports on the 

battery pack. Press the ON / OFF button to start charging the device 

For more information, please visit: http://aluratek.com/warranty-return-policy

You can register your product online at: http://aluratek.com/product-registration

E-mail: 

Web: 

Local (Tustin, CA):

Toll free:

Aluratek warrants this product against defect in material or workmanship 

for 

1 Year from the date of purchase.

If you need further assistance, please contact the Aluratek support 

department for troubleshooting prior to returning this device.

WARNING!!! This equipment has been tested and found to comply with the 

limits of a Class B digital device, pursuant to part 15 of the FCC rules. These 

limits are designed to provide reasonable protection against harmful 

interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instruction, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by whatever measures may be 

required to correct the interference.

The power status LEDs will light up according to charging capacity.