Whirlpool UXT4230ADW Instrução De Instalação

7. Drill Electrical Opening

Using a 1

¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked 

previously at the electrical strain relief.

OPTIONAL: Using a 

¹⁄₈" (3 mm) drill bit, drill pilot holes for the 

dots marked previously at each mounting tab at an approximate 
45° angle in an upward direction.

8. Prepare Range Hood Vents and 

Mounting Tabs

■

Install a UL Listed/CSA Approved 

¹⁄₂" (13 mm) strain relief (A).

■

Start a #8-18 x 

⁵⁄₈" (4.2 x 16 mm) truss-head screw into the 

mounting tab (F) on each side of the range hood as shown in 
the inset. Insert the screws approximately 2 turns into the 
mounting tab holes.

■

Using a #2 Phillips screwdriver remove the 2 screws and 
remove the top, front rectangular vent cover (E). Go to Step 
12.

■

For top vent installations, remove the top, rectangular vent 
knockout (C).

For wall vent installations, remove the rear rectangular vent 
knockout (B).

■

Remove both top knockouts (C and D).

9. Attach Vent Damper or Transition 

■

Using (2) short Phillips head screws, install the 3

¹⁄₄" x 10" 

(8.3 x 25.4 cm) rectangular damper over the top or rear vent 
knockout removed in Step 8.

NOTE: If the wall cap used has a damper and it interferes 
with the rectangular damper, remove the rectangular damper 
flap.

■

Using (2) short Phillips head screws, install the 7" (17.8 cm) 
round vent mounting plate over the vent knockouts removed 
in Step 8. Position the wide flange (C) to the front.

NOTE: An optional 7" (17.8 cm) round damper (A), Part 
Number W10355451, and a 7” (17.8 cm) round vent mounting 
plate (B), Part Number W10388168, are available as 
accessories. For information on ordering, see the “Assistance 
or Service” section.

■

If installing the optional round damper, position it over the 
round vent mounting plate.

A

B

C

D

E

F

A

B

C