KitchenAid KESB900ESS-SS Utilização E Cuidado

Remove/Replace Drawer

Remove all items from inside the baking drawer or premium 
storage drawer, and then allow the range to cool completely before 
attempting to remove the drawer.

To Remove:

1. Open the drawer to its fully open position.

2. Using a flat-blade screwdriver, gently loosen the drawer from 

the glide alignment notch, and then lift up the drawer 
alignment tab from the glide.

3. Repeat Step 2 on the other side. The drawer is no longer 

attached to the drawer glides. Using both hands, pick up the 
drawer to complete the removal.

To Replace:

1. Align the forward drawer notches with the notches in the 

drawer glides on both sides. Place the rear alignment tabs into 
the drawer glides on both sides.

2. Push the drawer in all the way.

3. Gently open and close the drawer to ensure it is seated 

properly on the glides on both sides.

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, 
refer to the warranty page in this manual and scan the code there with your mobile device, or visit http://kitchenaid.custhelp.com. In 
Canada, visit http://www.kitchenaid.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:

KitchenAid Brand Home Appliances

 

Customer eXperience Center

 

553 Benson Road

 

Benton Harbor, MI 49022-2692

In Canada:

KitchenAid Brand Home Appliances

 

Customer eXperience Centre

 

200 - 6750 Century Ave.

 

Mississauga, Ontario L5N 0B7

Please include a daytime phone number in your correspondence.

C

A

B

A

B

PROBLEM SOLVER

PROBLEM

POSSIBLE CAUSES AND/OR SOLUTIONS

Power supply cord is unplugged - Plug into a grounded outlet.

ENERGY SAVE is active, and the display is blank - Press any keypad on the control to display the 
time of day. See the “Electronic Oven Controls” section for more information.

Household fuse is blown, or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker. 
If the problem continues, call an electrician.

The control displays an F9 or F9 E0 error code - The electrical outlet in the home may be miswired. 
Contact a qualified electrician to verify the electrical supply.

The control knob is not set correctly - Push in knob before turning to a setting.

On ceramic glass models, the oven control lockout is set - See the control lock keypad feature in the 
“Feature Guide.”

Cookware is not the proper size - Use cookware about the same size as the surface cooking area, 
element or surface burner. Cookware should not extend more than 

¹⁄₂

" (1.3 cm) outside the cooking area.

Control knob set to incorrect heat level - See “Cooktop” section.

Range is not level - Level the range. See the Installation Instructions.

Element cycling due to a temperature limiter - This is normal operation. The element may cycle on 
and off to keep the cooktop from overheating.