Maytag M1BXXGMYw Ficha De Dados

1. Remove the FreshFlow™ Produce Preserver pouches from 

the packaging.

2. Lift up on the housing to remove it from the mounting tab. 

3. Open the housing by pulling up and out on the back of the 

top of the housing.

4. Place both pouches inside the housing, then snap the 

housing back together.

5. Place the housing back on the mounting tab.

The produce preserver comes with a status indicator, which 
should be activated and installed at the same time the pouches 
are installed. 

1. Place the indicator face-down on a firm, flat surface.

2. Apply pressure to the bubble on the back of the indicator until 

the bubble pops, to activate the indicator.

3. Slide open the cap on the top of the produce preserver 

housing.

4. Place the indicator in the top of the housing, facing outward.

5. Slide the cap closed, and check that the indicator is visible 

through the rectangular hole in the cap.

NOTE: The cap will not easily close if the indicator’s bubble 
has not been popped.

The disposable pouches should be replaced every 6 months, 
when the status indicator has completely changed from white to 
red. 

To order replacements, contact us. See “Accessories” for 
information on ordering. 

1. Remove the used pouches from the produce preserver 

housing.

2. Remove the used status indicator.

3. Install the replacement pouches and status indicator using 

the instructions in the previous sections.

The temperature controls are located at the top front of the 
refrigerator or freezer compartments. 

For your convenience, the temperature controls are preset at the 
factory. When you first install your refrigerator, make sure the 
controls are still set to the recommended setting as shown.

IMPORTANT: 

■

The recommended setting should be correct for normal 
household refrigerator use. The controls are set correctly 
when milk or juice is as cold as you like and when ice cream 
is firm.

■

Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has 
cooled completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature 
controls to a colder than recommended setting will not cool 
the compartments any faster.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls. 

Styles 1 and 2 - Press and hold TEMP for 3 seconds to turn 
cooling off. To turn cooling back on, press and hold TEMP again 
for 3 seconds.

Style 3 - Move the dial control to the word OFF. To turn cooling 
back on, move the dial control to the desired temperature setting.   

NOTE: Neither compartment will cool when the control is set to 
OFF.