Premium PRF24600MS Manual
9
Loud noises
Whether the food is leveled, whether the
refrigerator is balanced;
Whether the refrigerator parts are properly
placed.
refrigerator is balanced;
Whether the refrigerator parts are properly
placed.
7.1 Warm tips:
◆
◆
The refrigerator enclosure may release heat during operation especially
during the summer; this is caused by radiation of the condenser, and it is a
normal phenomenon.
◆
normal phenomenon.
◆
Condensation: condensation phenomenon will be detected on the exterior
surface and door seals of the refrigerator when the environmental humidity
is high; this is a normal phenomenon and the condensation can be wiped
away with a dry towel.
◆
is high; this is a normal phenomenon and the condensation can be wiped
away with a dry towel.
◆
Buzz: A buzz will be generated by the running compressor specially when
starting up or shutting down.
8. TIPS FOR ENERGY SAVING
Try not to open the door too often, especially when the weather is wet and
hot. Once you open the door, close it as soon as possible.
Every now and then check if the appliance is adequately ventilated
(adequate air circulation behind the appliance).
In normal temperature conditions, please arrange the thermostat at the
middle setting.
Before loading the appliance with packages of fresh food, make sure they
are cooled to environment temperature.
Ice and frost layer increase energy consumption, so clean the appliance as
soon as the layer is 3-5 mm thick.
The outer condenser and the rear wall should be always clean free of dust or
any impurities.
Always consider the instructions stated in the “Positioning and Energy
Saving Tips” sections; otherwise the energy consumption might be
substantially higher.
◆
8. TIPS FOR ENERGY SAVING
Try not to open the door too often, especially when the weather is wet and
hot. Once you open the door, close it as soon as possible.
Every now and then check if the appliance is adequately ventilated
(adequate air circulation behind the appliance).
In normal temperature conditions, please arrange the thermostat at the
middle setting.
Before loading the appliance with packages of fresh food, make sure they
are cooled to environment temperature.
Ice and frost layer increase energy consumption, so clean the appliance as
soon as the layer is 3-5 mm thick.
The outer condenser and the rear wall should be always clean free of dust or
any impurities.
Always consider the instructions stated in the “Positioning and Energy
Saving Tips” sections; otherwise the energy consumption might be
substantially higher.
◆
The appliance should be located in the coolest area of the room, away
from heat producing appliances or heating ducts, and out of the direct
sunlight.
◆
sunlight.
◆
Let hot foods cool to room temperature before placing them in the
appliance. Overloading the appliance forces the compressor to run longer.
Foods that freeze too slowly may lose quality or spoil.
◆
Foods that freeze too slowly may lose quality or spoil.
◆
Be sure to wrap foods properly, and wipe containers dry before placing
them in the appliance. This cuts down on frost build-up inside the
appliance.
◆
appliance.
◆
Appliance storage bin should not be lined with aluminum foil, wax paper,
or paper toweling. Liners interfere with cold air circulation, making the
appliance less efficient.
appliance less efficient.