KitchenAid KSEG950ESS-SS Ilustrações Dimensionais

8.8 – 16.5 KW

7.8 – 12.5 KW

40 or 50

194°F (90°C)

16.6 – 22.5 KW 12.6 – 18.5 KW 50

194°F (90°C)

KSDG950E

KSEG950E

This range is design-certified by CSA International for use with Natural 
gas or, after proper conversion, for use with LP gas.
•  This range is factory-set for use with Natural gas. See “Gas

Conversions” section. The model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door has
information on the types of gas that can be used. If the types of gas
listed do not include the type of gas available, check with the local
gas supplier.

LP Gas Conversion:
Conversion must be done by a qualified service technician. No attempt 
shall be made to convert the appliance from the gas specified on the 
model/serial/rating plate for use with a different gas without consulting 
the serving gas supplier. See “Gas Conversions” section.

•  Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the range

location. A smaller size pipe on longer runs may result in insufficient
gas supply. With LP gas, piping or tubing size can be ½" (1.3 cm)
minimum. Usually, LP gas suppliers determine the size and materials
used in the system. 

NOTE: Pipe-joint compounds that resist the

action of LP gas must be used. Do not use TEFLON

®†

 tape.

Flexible metal appliance connector:
•  If local codes permit, a new CSA design-certified, 4 to 5 ft

(122 to 152.4 cm) long, 

1

/

2

" (1.3 cm) or 

3

/

4

" (1.9 cm) I.D.

(inside diameter), flexible metal appliance connector
may be used for connecting range to the gas supply line.

•   A 

1

/

2

" (1.3 cm) male pipe thread is needed for connection

to the female pipe threads of the inlet to the appliance
pressure regulator.

•  Do not kink or damage the flexible metal tubing when moving

the range.

•  Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve.
This valve should be located in the same room but external
to the range opening, such as an adjacent cabinet. It should
be in a location that allows ease of opening and closing. Do not block
access to shutoff valve. The valve is for turning on or shutting off gas
to the range.

Because Whirlpool Corporation includes a continues commitment to improve our products, 

we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, 

see Installation Instructions packed with product. Specifications subject 
to change without notice.

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

•  Range must be connected to the proper electrical voltage and

frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located on the right vertical surface of the oven
door frame. Refer to the illustrations in the “Product Dimensions”
section of the “Location Requirements” section.

•  This range is manufactured with a 4-wire power supply cord rated at

240 volts, 40 amps, rated at 194°F (90°C) and investigated for use
with this range.

†®

TEFLON is a registered trademark of E.I. Du Point De Nemours and Company.

Ref. W10665257A

03/15

Page 1 of 2

*  The NEC calculated load is less than the total connected load listed

on the model/serial/rating plate.

IMPORTANT: Range must be level after installation. Follow the 
instructions in the “Level Range” section. Using the cooktop as a 
reference for leveling the range is not recommended.

*  Range can be raised approximately 1" (2.5 cm) by adjusting the

leveling legs.