Frigidaire FHWC3025MS Manual Do Proprietário

Use ¹⁄

8

” (3 mm) drill bit and drill 4 pilot holes as shown. 

NOTE: Make the drill holes on the thin area of the slot.  

 

 

 

Install the 4 - .45 cm x 1.3 cm mounting screws in 

  pilot holes. Leave about ¼” (6.4 mm) space between   

  screw heads and cabinet to slide range hood into place. 

 

 

 

For roof installations, remove the top rectangular 

  vent knockout. For wall installations, remove the rear    

  rectangular vent knockout. 

 

 

 

 

 

 

 

 

 

Install the 3¼” x 10” (8.3 x 25.4 cm) vent connector. 

 Attach to range hood with the .35 x .95 cm screws 

  that you previously removed (step 1)  and remove tape  

 from damper flap.

  

If a vent damper is installed with a wall cap with  

  damper, check that they do not interfere with each 

 other. Remove the vent connector damper flap if 

  they interfere. 

¹⁄4”

(6.4 mm)

A

A. Drill pilot hole

A

B

A. Vertical connector

B. 3.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal connector

For direct wire installations, run the home power 

  supply cable according to the National Electric Code 

  or CSA standards and local codes and ordinances. 

  There must be enough wiring from the fused disconnect  

 (or circuit breaker) box to make the connection in the 

 hood electrical terminal box.  

 

  

 

Remove the screw from the  

 terminal box cover.  

 Remove terminal box cover  

  and set aside. 

 

 

 

Remove the power supply knockout from the top 

  or rear of the vent hood (depending on the incoming 

  location of your home power supply cable) and  

  install a UL listed or CSA approved ½” strain relief. 

 

 

 

 

 

 

 

 

 

Using 2 or more people, lift the hood into final position. 

  Feed enough electrical wire through the ½” UL listed  

  or CSA approved strain relief to make connections in  

 the terminal box. Tighten the strain relief screws.

Position the range hood so that the large end of 

  the keyhole slots are over the mounting screws. 

  Then push the hood toward the wall so that the screws  

  are in the neck of the slots. Tighten the mounting screws,  

  making sure the screws are in the narrow neck of slots.

Connect ventwork to hood. Seal joints with vent  

  clamps or duct tape to make secure and airtight.

Check that back draft dampers work properly.

A

B

A. Terminal box cover
B. Screw

A

A. Power supply  
     knockout