Le Cache European Country Euro 1400 172-Bottle Wine Cellar - Chocolate Cherry Finish Manual Do Proprietário

L E   C A C H E   P R E M I U M   W I N E   C A B I N E T S 

 

2.  Check the ambient temperature in the space outside the condenser coils while the 

cooling unit is running, making sure that the difference between this temperature and 
the Minimum Set Point is no more than 25°F. 

3.  Increase the supply of cool air to the space outside the condenser coils, using a fan or an 

exhaust system to remove heat from the space. 

4.  Raise the Minimum Set Point on the cooling unit 

5.  Make sure that the “Quick Chill” and “Energy Saver” features are not enabled 

 

The cooling unit is dripping inside the cabinet and/or the cabinet is having problems 
with condensation. 

The cooling unit does not generate water.  If the cooling unit is dripping, or the cabinet is 
having excess condensation, it is because the cooling unit is running too much and/or the 
cabinet does not have an airtight seal from the ambient environment. 

To eliminate dripping and condensation, do the following: 

1.  Raise the Minimum Set Point of the cooling unit to 58 degrees. 

2.  Make sure the cellar has good seals, especially at the door(s), and repair any leaks 

immediately. 

3.  Keep the first 3-4 rows clear in the column directly below the cold-air discharge (front 

column only). This will stop the cold air from "splashing" against the center post.  See 
Chapter VII for more information. 

4.  If your wine cabinet is less than half full, build the thermal mass to reduce the cycle time 

of the cooling unit. If you don't have enough wine, use soda cans, water bottles, etc. 

5.  Make sure that the lock shafts have foam sleeves. For additional insulation, wrap the lock 

tab with electrical tape.  

6.  If condensation is coming into contact with the cabinet’s wood, wipe it away frequently 

to prevent damage to wood surfaces, warping of the doors and mold. 

 

I can't insert my key into the lock because the notches aren't lined up. 

If the inner and outer notches in the lock become misaligned, you'll need to file off the tab 
on the key. Once the tab is filed off, you'll be able to insert the key into the lock.