VintageView Vino Pins for Drywall Surfaces (with Collars) Instrução De Instalação
Vino Pins (VP-DWC & VP-X) Installation Instructions for Drywall Surfaces
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501 • VintageView.com
Required tools: •Level •2 Wrenches (7/16 inch) •Drill •1/2 inch (12.7mm) drill bit •5/32 inch (4mm) drill bit
Starter Kit Included Parts: • 1 Vino Pins Neck •1 Vino Pins Base •2 Vino Pins Collars •2 Toggle Bolts •1 Machine/Lag Stud •2 Nuts
Figure B
1. Mark the mounting hole locations - Reference
Figure A below to verify appropriate minimum clearances
around the Vino Pins in the desired installation area. Use
a level to ensure the printed template is horizontal along
the long edge and mark the hole locations by piercing
the template with an awl or a screw at the center of the
2 marks corresponding with the bottle direction chosen
earlier.
4
3/8"
13"
7
1/2"
5/8"
2
3/4"
2
3/4"
Figure A
2. Drill the anchor holes - Using the 5/32 inch (4mm)
bit, drill pilot holes in your wall to see if your hole locations
are over studs. If you do hit a stud, skip to Wall Stud
Mounting. Otherwise, drill a 1/2 inch (12.7mm) hole for
the Toggle Bolts at the pilot hole locations (Figure C).
Figure C
(Optional) Extension Kit Included Parts: •1 Vino Pins Neck Extension •2 Studs •1 Vino Pins Base Extension
Before you begin, choose the direction the bottle necks should point
If the bottle necks are to point to the right, the base pin
must be installed to the left of the neck pin.
If the bottle necks are to point to the left, the base pin
must be installed to the right of the neck pin.
Critical Note: These installation instructions are for attaching Vino Pins only to drywall surfaces with a minimum thickness of 1/2 inches (12.7mm).
If your wall surface does not meet this minimum requirement, please contact your VintageView supplier to obtain appropriate mounting hardware
for your wall surface. Installing Vino Pins on wall surfaces that do not meet this minimum criteria may result in failure of the installation and serious
damage or injury.
3. Prepare the Toggle Bolts - Screw the expanding wing
nut onto the bolt so that the wings fold away from the head
of the bolt. Thread the nut all the way to the head of the
bolt and then back it off about one full turn to make sure
the wings of the nut can open and close without touching
the bolt head (Figure D).
Figure D