Perlick 24" 45 Bottle Signature Series Wine Reserves - Solid Stainless Door - Left Hinge Guia De Utilização

DOOR OPTIONS

Perlick units offer a variety of door panel design

alternatives; solid stainless steel, solid wood overlay,

stainless steel glass, wood overlay glass, solid stain-

less steel drawers and solid wood overlay drawers.

This, together with door swing choices, result in a

variety of possible combinations.

Solid stainless steel, stainless steel glass doors and

solid stainless steel drawers are shipped from the

factory with decorative stainless steel panels and

handles in place on the appliance, ready for use.

Solid wood overlay, glass wood overlay doors and

solid wood overlay drawers are designed to accept a

decorative front panel to match surrounding cabi-

netry and door handles. This panel and door handle

will be provided by the customer.

All Perlick units accept any of the above door con-

figurations and are fully hinge reversible and inter-

changeable. See page 15 for Door Reversing Instruc-

tions.

IMPORTANT NOTE: Units with a freezer can only

utilize a solid stainless steel door, solid wood

overlay door, solid stainless drawers or solid

wood overlay drawers (stainless steel glass or

wood overlay glass doors will sweat if installed

on a freezer section).

IMPORTANT NOTE: Stainless steel glass or wood

overlay glass doors may sweat in conditions with

relative humidity over 75 percent.

HANDLE INSTALLATION

CAUTION: Handle mounting on wood overlay

door should be mounted on overlay panel only

(not the door) to avoid damage to the factory

door.

Handle must be attached to overlay before

mounting overlay onto door. Mark rear of wood

overlay panel with handle fastening locations.

Drill through wood overlay panel at marked

locations taking care not to damage the wood over-

lay panel.

Countersink screw heads so screw heads are

flush with backside of panel. Attach handle to over-

lay panel.

CAUTION

Proper wood working materials and equipment

should be used to avoid damage or errors in

workmanship.

With the unit secured in position, open the

door and make sure panel pre-drilled holes align

with door frame holes.

Loosely attach four corners of the overlay

panel to the door using #10 x 1” wood screws, in-

stalled through the door frame from the rear.

Check for overall wood overlay panel fit,

position and function. Make minor adjustments as

necessary. When panel

is properly aligned,

tighten mounting screws securely. Install the rest

of the mounting screws and tighten securely.

CAUTION: Do not over-tighten wood overlay

attachment screws as this may damage factory

supplied doorframe.

Document No. Z2305