Perlick 15" Signature Series Clear Ice Maker - Solid Stainless Door - Right Hinge Guia De Utilização

5

* To prevent damage to the water supply line, drain the Ice Maker when air temperature is

below freezing,  See section 8.

* This Ice Maker requires no clearance at either side.  But allow enough space at rear for

water supply and drain connections and at least 15" (approx. 38 cm) clearance at front.

This Ice Maker requires a ground that meets the national and local electrical
code requirements.  To prevent possible severe electrical shock injury to
individuals or extensive damage to equipment, install a proper ground wire to
this Ice Maker.  Remove the plug from the mains socket before any maintenance,
repairs or cleaning is undertaken.

* This Ice Maker must be plugged into the separated power receptacle which has enough

capacity. The maximum allowable voltage variation should not exceed ± 10 percent of the
nameplate rating.  See the Nameplate.

* If electrical service to the outlet is not adequate, an electrical permit and services of a

licensed electrician are required.

Normal operating ambient temperature should be within 45°F (7°C) to 100°F
(38°C);  Normal operating water temperature should be within 45°F (7°C) to
95°F (35°C).  Operation of the Ice Maker, for extended periods, outside of
these normal temperature ranges may affect production capacity.

For best operating results:

* The Ice Maker should not be located next to ovens, grills or other high heat producing

equipment.

* The location should provide a firm foundation for the equipment.  Level the Ice Maker from

side to side and front to rear.

* For outdoor installation, avoid locating the Ice Maker where moisture can continuously 

drip on cabinet