Philips AJ5030/05 Folheto

Note

You can only use AC power as power supply. The lithium

•

CR2032 battery is only for back-up purpose.

When power is disconnected, the display backlight is off.

•

When

is displayed, you need replace the battery as indicated.

Connect power

Caution

Risk of product damage! Ensure that the power voltage

•

corresponds to the voltage printed on the back or underside of

the clock radio.

Risk of electric shock! When you unplug the AC adapter, always

•

pull the plug from the socket. Never pull the cord.

Plug and set

The clock radio has “plug and set” feature. When power is

connected, the clock is set automatically.

Select time zone

Check if the time of the clock radio is consistent with the local time.

If not, adjust the time zone settings according to your location.

In standby mode, press TIME ZONE.

The current time zone number blinks on the display panel.

Press TIME ZONE repeatedly to select time zone.

For United Kingdom and Ireland:

Western European Time (WET)

+0 (by default)

Set clock

In standby mode, you can set clock manually.

Select DST (daylight saving time) mode

For countries with daylight saving time (DST), the clock radio offers

you DST option to adjust summer time.

In standby mode, press and hold 12/24H·DST for two seconds.

The clock advances by one hour.

Tip

To exit DST mode, repeat the above operation.

•

To select 12/24 hour format, press

•

12/24H·DST repeatedly.

4 Listen to FM radio

Tune to FM radio stations

Note

Position the antenna as far as possible from TV, VCR, or other

•

radiation source.

For optimal reception, fully extend and adjust the position of the

•

antenna.

Note

To turn on/off radio, press

•

RADIO.

Store FM radio stations automatically

You can store up to 20 FM radio stations.

Press RADIO to turn on the radio.

Press and hold PROG for two seconds.

The clock radio stores all the available FM radio stations

and broadcasts the first available station automatically.

Store FM radio stations manually

Tune to an FM radio station.

Press PROG.

The preset number begins to blink.

Press PRESET +/- or TUNING +/- repeatedly to select a

number.

Press PROG again to confirm.

Repeat Steps 1 to 4 to store other stations.

Note

To remove a pre-stored station, store another station in its

•

place.

Select a preset radio station

In tuner mode, press PRESET +/- to select a preset number.

Adjust volume

5 Set alarm timer

Set alarm time

In standby mode, you can set two alarms to ring at different time.

Select alarm sound

For the alarm sound, you can select buzzer, your last heard radio, or

the melody stored in the clock radio.

Adjust AL1/RADIO·BUZZ·

1 or AL2/RADIO·BUZZ· 2 to

select alarm sound for Alarm 1/Alarm 2.

Activate/deactivate alarm timer

Press AL1/AL2 to view alarm settings.

Press AL1/AL2 again to activate or deactivate the alarm

timer.

AL1 or AL2 appears if alarm timer is on and disappears

if it is off.

To stop alarm, press the corresponding

•

AL1/AL2

(or RADIO).

The alarm repeats ringing for the next day.

•

Note

When alarm sounds, you cannot adjust volume by rotating

•

VOL.

Snooze alarm

When alarm sounds, press SNOOZE.

The alarm snoozes and repeats ringing five minutes later.

To adjust alarm interval (in minutes), press SNOOZE repeatedly.

Other features

Set sleep timer

This clock radio can switch to standby mode automatically after a

preset period.

Press SLEEP repeatedly to select the sleep timer period

(in minutes).

When the sleep timer is activated,

appears.

To deactivate the sleep timer, press SLEEP repeatedly until [OFF]

(off) appears.

Project time onto wall/ceiling

By projecting time onto a wall or ceiling, this clock radio offers you

a unique way to read time in the dark.

Warning

Risk of damage to eyes! Do not look at the glowing red light

•

constantly.

Note

Before you start, switch

•

CLOCK/SET AL1/SET AL2/SET TIME

to CLOCK.

Press PROJECTION to turn on the projector.

Rotate the projector to adjust the projected direction.

Rotate the focus ring to adjust the image sharpness.

To reverse the projected image, switch FLIP to left or right.

Tip

To turn off the projector, press

•

PROJECTION again.

Adjust display brightness

Press BRIGHTNESS repeatedly to select different brightness levels:

high, mid, and low.

7 Product information

Note

Product information is subject to change without prior notice.

•

5 10 15 20 25 30

15 30 60 90 120

off

Specifications

Amplifier

Rated Output Power

0.6W RMS

Tuner

Tuning Range

FM: 87.5 - 108 MHz

Sensitivity

- Mono, 26dB S/N Ratio

FM: <22 dBu

Search Selectivity

FM: <28 dBu

Total Harmonic Distortion

FM: <3%

Signal to Noise Ratio

FM: >45 dB

General information

AC power

100-240 V~, 50/60Hz

Operation Power Consumption

<3W

Standby Power Consumption

<1W

Dimensions

- Main Unit (W x H x D)

135 x 135 x 60.5 mm

Weight

- With Packing

- Main Unit

0.6 kg

0.3 kg

8 Troubleshooting

Warning

Never remove the casing of this clock radio.

•

To keep the warranty valid, never try to repair the clock radio

yourself.
If you encounter problems when using this clock radio, check the

following points before requesting service. If the problem remains

unsolved, go to the Philips web site (www.philips.com/welcome).

When you contact Philips, ensure that the clock radio is nearby and

the model number and serial number are available.
No response from the unit

Disconnect and reconnect the AC power plug, then turn on

•

the unit again.

Poor radio reception

Increase the distance between the unit and your TV or

•

VCR.

Fully extend the FM antenna.

•

9 Notice

This product complies with the radio interference requirements of

the European Community.

Any changes or modifications made to this device that are not

expressly approved by Philips Consumer Lifestyle may void the

user’s authority to operate the equipment.

Note

The type plate is located on the bottom of the apparatus.

•

Your product is designed and manufactured with high quality

materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it

means that the product is covered by the European Directive 2002/96/

EC.
Please inform yourself about the local separate collection system

for electrical and electronic products.
Please act according to your local rules and do not dispose of

your old products with your normal household waste. Correct

disposal of your old product helps to prevent potential negative

consequences for the environment and human health.

Your product contains batteries covered by the European Directive

2006/66/EC, which cannot be disposed with normal household

waste.Please inform yourself about the local rules on separate

collection of batteries because correct disposal helps to prevent

negative consequences for the environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to

make the packaging easy to separate into three materials: cardboard

(box), polystyrene foam (buffer) and polyethylene (bags, protective

foam sheet.)
Your system consists of materials which can be recycled and reused

if disassembled by a specialized company. Please observe the local

regulations regarding the disposal of packaging materials, exhausted

are the property of Koninklijke Philips Electronics N.V. or their

respective owners. Philips reserves the right to change products at

any time without being obliged to adjust earlier supplies accordingly.

AJ5030_05_UM_V1.0.indd 2

2011-4-15 14:23:32