Philips DCM278 DCM278/37 Manual Do Utilizador
Códigos do produto
DCM278/37
20
Insert the battery with its polarities
•
(+/– signs) aligned as indicated.
Replace the battery.
Replace the battery.
•
Aim the remote control directly at the
•
sensor on the front of the unit.
Cannot display some files in USB device
The number of folders or files in the USB
•
device has exceeded a certain limit. This
phenomenon is not a malfunction.
The formats of these files are not
phenomenon is not a malfunction.
The formats of these files are not
•
supported.
USB device not supported
The USB device is incompatible with the
•
unit. Try another one.
Poor radio reception
Increase the distance between the unit
•
and your TV or VCR.
Fully extend and adjust the FM antenna.
Fully extend and adjust the FM antenna.
•
Clock/timer setting erased
Power has been interrupted or the power
•
cord has been disconnected.
Reset the clock/timer.
Reset the clock/timer.
•
Timer does not work
Set the clock correctly.
•
Switch on the timer.
•
10 Troubleshooting
Warning
Never remove the casing of this apparatus.
•
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site www.
philips.com/welcome. When you contact Philips,
ensure that the apparatus is nearby and the
model number and serial number are available.
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site www.
philips.com/welcome. When you contact Philips,
ensure that the apparatus is nearby and the
model number and serial number are available.
No power
Ensure that the AC power plug of the
•
unit is connected properly.
Ensure that there is power at the AC
Ensure that there is power at the AC
•
outlet.
To save power, the unit switches to
To save power, the unit switches to
•
standby automatically 15 minutes after
a play reaches the end and no control is
operated.
a play reaches the end and no control is
operated.
No sound
Adjust the volume.
•
No response from the unit
Disconnect and reconnect the AC power
•
plug, then turn on the unit again.
No disc detected
Insert a disc.
•
Check if the disc is inserted with the print
•
side facing inward.
Wait until the moisture condensation at
Wait until the moisture condensation at
•
the lens has cleared.
Replace or clean the disc.
Replace or clean the disc.
•
Use a finalized CD or correct format disc.
•
Remote control does not work
Before pressing any function button, first
•
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control instead of the main unit.
Reduce the distance between the remote
•
control and the unit.
EN