Sony PCNA-MR10 Manual

When 

 is shown for a server, RoomLink™ does not recognize the computer’s 

availability and fails to connect. 

Try the following steps:

Using the Remote Commander, select Connect from the on-screen 
submenu. 

Press OK.

If these steps do not connect the server, check the following:

❑

If necessary, bring the computer out of Standby or Hibernate mode. 
(You can configure your computer to enable the network media receiver 
to automatically resume from Standby or Hibernate modes.)

❑

Verify the computer is turned on.

❑

Verify the network cable connections are secure.

❑

If using a network switch device or a router device with a built-in 
network switch, verify that the equipment is turned on.

❑

Verify the network status is up.

You can set RoomLink™ to stop displaying the Select a server screen every time 
you access a feature, such as TV, Video, Music or Photo. Preset a default server 
for each feature. See “Connecting to a server automatically” on page 58, for 
details.

❑

This RoomLink recording feature is preset to automatically stop 30 minutes 
after pressing the REC button. After you start recording, the length of the 
recording session can be extended by 30-minute increments (up to a total of 
6 hours) each time you press the REC button.

❑

You may not have enough hard drive space on your VAIO® computer. 
Delete unnecessary files to free up additional space.