Sierra Wireless DART 300 Manual Do Utilizador
References
DART 300 Modem
Page 110
2110212 Rev 1.0
Table 12-5: WS-Registers in CDPD Mode (continued)
Register Description
Range
Default
Units
56
Network Registration Status (Read Only)
Value Meaning
0 Unregistered
0 Unregistered
1 Registered
0, 1
60
PAD Time Independent Escape Sequence (TIES)
This enables or disables use of the AT+++ sequence to escape
to command state while on-line in a PAD mode. It has no
meaning in SLIP and PPP modes.
to command state while on-line in a PAD mode. It has no
meaning in SLIP and PPP modes.
Value Meaning
0 Disabled
1
1
Enabled (AT+++ where AT must be in uppercase)
(Default)
(Default)
0, 1
1
62
PAD Local On-Line Echo
Enables / disables the echoing of data received from the host
(DTE) while in the on-line PAD condition. If enabled, the
PAD will echo each character received from the host while in
the on-line (PAD packet) condition. If both On-line Echo and
On-line Editing (+WS72) are enabled, upon receipt of the
backspace character (+WS73) the PAD will echo the
following character sequence to the host: <backspace
character > <SP> <backspace character> where the
backspace character is that defined in +WS73
(DTE) while in the on-line PAD condition. If enabled, the
PAD will echo each character received from the host while in
the on-line (PAD packet) condition. If both On-line Echo and
On-line Editing (+WS72) are enabled, upon receipt of the
backspace character (+WS73) the PAD will echo the
following character sequence to the host: <backspace
character > <SP> <backspace character> where the
backspace character is that defined in +WS73
Value Meaning
0 Disabled
1
1
Enabled (Default)
0, 1
1
63
PAD Forwarding Character Feature Mask
Bit mask used to enable or disable the PAD’s use of the
primary forwarding character (defined in +WS64). It also
determines if the forwarding character is to be included in the
packet.
primary forwarding character (defined in +WS64). It also
determines if the forwarding character is to be included in the
packet.
Bit Meaning
0
0
If set, the PAD will terminate and send the packet
upon receipt of the primary forwarding character
from the host (DTE)
upon receipt of the primary forwarding character
from the host (DTE)
1
If set; the PAD will include the primary
forwarding character in the packet (i.e. will not
filter out the character). This is only meaningful if
bit 0 is set.
forwarding character in the packet (i.e. will not
filter out the character). This is only meaningful if
bit 0 is set.
2 – 7
Reserved.
0x03
64
PAD Primary Forwarding Character
Receipt of this character (if enabled by bit 0 of +WS63) will
cause the PAD to terminate the packet, and begin transmission
of the packet on the CDPD network.
cause the PAD to terminate the packet, and begin transmission
of the packet on the CDPD network.
0 – 255
13 <CR>