Kenwood KDC152 Manual Do Utilizador

Página de 44
3
ENGLISH
Preparation
How to attach/detach the faceplate
2
1
1
2
 Do not expose the faceplate to direct 
sunlight, excessive heat, or humidity. Also 
avoid places with too much dust or the 
possibility of water splashing.
 The faceplate is a precision piece of 
equipment and can be damaged by shocks 
or jolts.
 To prevent deterioration, do not touch the 
terminals of the unit and faceplate with 
your fingers.
How to reset your unit
If this unit fails to operate properly, press the 
reset button.
The unit returns to factory 
settings when the reset 
button is pressed.
How to prepare the remote 
controller (RC-405)
When you use the remote controller for the 
first time, pull out the insulation sheet.
 
If the effectiveness of the remote 
controller decreases, replace the battery.
2
3
4
1
CALIFORNIA, USA ONLY
This perchlorate WARNING applies only 
to the product sold or distributed in 
California USA “Perchlorate Material–special 
handling may apply, See www.dtsc.ca.gov/
hazardouswaste/perchlorate.”
Caution:
 Do not set the remote control in hot places 
such as on the dashboard.
 Lithium battery.
  Danger of explosion if the battery is 
incorrectly replaced. Replace only with the 
same or equivalent type.
 The battery pack or batteries shall not be 
exposed to excessive heat such sunshine, 
fire or the like.
 Keep battery out of reach of children and in 
original package until ready to use. Dispose 
of used batteries promptly. If swallowed 
contact physician immediately.
Insulation sheet
Discs that cannot be used
 Discs that are not round.
 Discs with coloring on the recording 
surface or discs that are dirty.
 You cannot play a Recordable/ReWritable 
disc that has not been finalized. (For the 
finalization process refer to your disc 
writing software, and your disc recorder 
instruction manual.)
 3-inch CD cannot be used. Attempt 
to insert using an adapter can cause 
malfunction.
Reset button
EN02-15_KDC-152[K]f.indd   3
EN02-15_KDC-152[K]f.indd   3
6/8/11   2:35:22 PM
6/8/11   2:35:22 PM