Sanyo DSR-C100 Manual Do Utilizador
Control terminals
5
VIDEO OUT terminal (BNC plug)
This terminal is used to connect the camera to a
component such as a monitor or camera control
unit.
component such as a monitor or camera control
unit.
6
RESET button
Press the RESET button if an abnormality occurs
with the camera. Settings are not changed
when the camera is reset in this way.
with the camera. Settings are not changed
when the camera is reset in this way.
7
Warning indicator
•
The warning indicator lights when the
camera power is turned on.
•
It flashes when there is a hard disk error or if
there is a problem with the backup battery.
GND
GND
GND
WARNING
DC13.8V
H
S
1 2 3 4 5 6 7
Terminal
Signal
Input/output voltage
1 H (HOLD-UP)
Alarm switch input signal
2.5 V or higher when alarm switch off/
0.4 V or lower when alarm switch on
0.4 V or lower when alarm switch on
2 GND
Alarm switch and suspicion switch ground 0 V
3 S (SUSPICION)
Suspicion switch input signal
2.5 V or higher when suspicion switch off/
0.4 V or lower when suspicion switch on
0.4 V or lower when suspicion switch on
4 GND
Warning ground
0 V
5 WARNING
Warning signal output
3.3 V or higher when warning generated
6 GND
Power supply ground
0 V
7 DC 13.8 V
Power supply input
13.8 V DC
L42A4/US (DSR-C100) GB 2001, 4, 16
8
English