Kidco G20 Manual Do Utilizador

Screw hinge spindles (c) into top and bottom
rails of gate section (h) until they are exten-
ded equally. These will be adjusted to the
correct length at a later stage so do not
tighten.

Repeat process on gate section (i) using latch

spindles (m).

Mounting Locking Side

Screws provided are

for

mounting directly

into wood. If mounting into brick, drywall
or other surfaces, use appropriate hard-
ware. If installing into hardwood (i.e. oak),
drilling a pilot hole may be necessary.

Hold template (j) against mounting surface in

line with opposite hinges, making sure end

marked

is even with floor.

Mark 4 screw hole positions.
Remove template.

Determine which direction the gate should

open. For stairways, gate should never

open out over stairs.

Using 2 screws (q), screw bottom locking
bracket (p) into lower set of screw holes with

opening side facing direction gate will open.

Fit locking latch (k) into locking latch bracket
(l).