DELL H200 Manual Do Utilizador

Hardware Installation

29

Installing the PERC H200 Modular Card

 

NOTE: 

For more information on removing and installing blade system parts, 

see your system’s Hardware Owner’s Manual or the User’s Guide from the 
Dell Support website at support.dell.com.

The storage controller card is located below the hard drive bays of the 
Dell  Blade system. 

To remove the storage controller card:

1 Remove the Dell Blade system from the Blade system chassis. 
2 Remove the system cover of the Blade system. 
3 Remove the system board and place it on a stable and flat surface.
4 Open the release lever to disconnect the storage controller card edge 

connector from the system board connector as illustrated in Figure 4-4.

5 Lift the storage controller card straight up from the system board as illustrated 

Figure 4-4.

Removing and Installing the Storage Controller Card

1

storage controller card

2

release lever

1

2

PERC H200.book  Page 29  Tuesday, July 13, 2010  4:15 PM