Western Telematic CMS-16 Manual Do Utilizador
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER", access the Command Mode from
a port with Supervisor Level command capability, and type /W SERVER [Enter].
a port with Supervisor Level command capability, and type /W SERVER [Enter].
/X Exit Command Mode
Exits Command Mode, When issued at the Net Port, also ends the telnet session. Note that
exiting from Command Mode will not terminate port connections.
exiting from Command Mode will not terminate port connections.
Any-to-Any Mode: Exits Command Mode.
●
Modem Mode: Disconnects and resets modem, hang-up message is sent, hardware line to
modem drops for 500 ms, and reset message is sent.
modem drops for 500 ms, and reset message is sent.
●
Availability: Supervisor / User
Format: /X [Enter]
Response: Disconnected
Format: /X [Enter]
Response: Disconnected
Appendix A. RS232 Port Interface
Figure A.1: RS232 Port Interface
DCD and DTR hardware lines function as follows:
When connected:
If either port is set for Modem Mode, the DTR output at either port reflects the
DCD input at the other end.
DCD input at the other end.
.
1.
WTI CMS-16; Console Management Switch -- User's Guide
file:///C|/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (57 of 59) [11/15/2000 10:52:03 AM]