Weber 675 Manual De Instruções
5
BUILT-IN SLEEVE GAS
LINE LOCATIONS
LINE LOCATIONS
475
675
Tolerances
A
5.0”
5.0”
B
10.1”
10.1”
C
2.5”
2.5”
+
1
⁄
16
-
1
⁄
16
+
1
⁄
16
-
1
⁄
16
+
1
⁄
32
-
1
⁄
32
BUILT-IN SLEEVE GAS LINE
LOCATIONS
The dimensions shown indicate the location of the gas
line inlet flange in the insulated sleeve. The support
members of the built-in structure must not impede
passage of the gas lines.
line inlet flange in the insulated sleeve. The support
members of the built-in structure must not impede
passage of the gas lines.
Area should be kept clear of sharp, jagged, or extremely
abrasive surfaces to avoid possible damage to gas supply
lines. Exercise caution when pulling gas lines through
built-in structure.
abrasive surfaces to avoid possible damage to gas supply
lines. Exercise caution when pulling gas lines through
built-in structure.
Note: Leave an access in the structure for gas supply
and regulator service.
and regulator service.
Figure 6
Support tubes