KitchenAid Gas Range Architect Series II Manual Do Utilizador
23
Warming drawer indicator light
The indicator light is located above the Warming drawer
thermostat control knob. It turns on when the control is set,
and stays on until the control is turned OFF (See Fig. 1).
Setting Warming Drawer
The thermostat control knob is used to select the
temperature for the warming drawer. It is located on the
control panel. The temperatures are approximate, and are
marked Lo, Med and Hi (See Fig. 1).
FOOD POISONING HAZARD. Do not let
food sit for more than one hour before or after cooking.
Doing so can result in food poisoning or sickness.
Always use potholders or oven mitts when
removing food from the warming drawer as cookware and
plates will be hot and you can be burned.
To set warming drawer:
1. Open warming drawer when cool and arrange warming
drawer rack as needed.
2. For best results, close the warming drawer and preheat
the drawer before adding food or plates. An empty
warming drawer will fully preheat in approximately 15
minutes.
3. Place food in warming drawer that is already at serving
temperature on warming drawer rack. Dinner plates
may be warmed also.
4. Push in and turn the warming drawer control knob in
either direction to the desired temperature setting (See
Fig. 1).
5. Always turn warming drawer control knob to OFF
position after use.
Important notes:
Always start with hot food when using the warming
drawer. DO NOT heat cold food in the warming drawer.
Self Clean can not be set when the warming drawer is
active.
The warming drawer is equipped with a catch that may
require extra force to open and close the drawer.
Setting Warming Drawer Control
(some models)
Fig. 1