KitchenAid Gas Range Architect Series II Manual Do Utilizador

Replacing oven light

Be sure the range is unplugged and all

parts are COOL before replacing oven light. Wear a

leather-faced glove for protection against possible broken

glass.
The oven light is located at the rear of the oven cavity and

is covered with a glass shield held by a wire holder. The

glass shield protects the light bulb and must be in place

whenever the oven is in use.

To replace the interior oven light bulb:

1. Turn electrical power off at the main source or unplug

the range.

2. Press wire holder to one side to release the glass

shield that covers the light bulb.

3. Replace light with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder

back into place.

5. Turn power on at the main source (or plug the

appliance in to an electrical outlet).

6. The clock will then need to be reset. To reset, see

Setting clock in this Use & Care Guide.

Care & Cleaning

wire
holder

glass
shield

General cleaning

Refer to the Cleaning recommendation table in the

Care & Cleaning section for more detailed information

about cleaning specific parts of the range.

Before manually cleaning any part of the

range, be sure all controls are turned OFF and the range

is COOL. The range may be hot and can cause burns.

Ammonia must be rinsed before operating

the oven. Provide adequate ventilation.

Aluminum foil and utensils

NEVER cover any slots, holes or

passages in the oven bottom or cover an entire oven

rack with materials such as aluminum foil. Doing so

blocks air flow through the oven and may cause

CARBON MONOXIDE poisoning. Aluminum foil linings

may trap heat, causing a fire hazard.
Aluminum foil - Use of aluminum foil on a hot cooktop

can damage the cooktop. Do not use thin aluminum

cooking utensils or allow aluminum foil to touch the

surface burners under ANY circumstances.

Aluminum utensils - The melting point of aluminum is

much lower than that of other metals. Care must be

taken when aluminum pots or pans are used on the

cooktop. If aluminum pans are allowed to boil dry when

using the cooktop, the utensil may be damaged or

destroyed.