Hobie Adventure Island Manual Do Utilizador

6.  With the up and down control lines loose, pull on them and re-
move them from the hull with the tubes.  If they get hung up inside 
the hull, you can cut whatever is preventing you from taking out 
the lines.  You will no longer need these lines and tubes with this 
kit.

7.  With the old tubes and lines removed, install the new tubes with 
lines that are in this kit into the holes that you just removed the old 
tubes from.  Getting the end fittings into the holes will be a tight 
squeeze, so you may need a small hammer to tap them into the 
holes so that they are fully installed.  IMPORTANT:  When these 
lines are installed, the right line will be for the DOWN control 
and the left line will be for the UP control.

8.  Use a socket or a wrench and unthread the 
bolt that passes through the center of the rud-
der housing.  This will allow the rudder to come 
apart.

9.  Feed the DOWN control line through the two holes that are just 
above the rudder pin.  When installed, the line will come on the 
inside of the rudder housing.

Upper Hole

Lower Hole

10.  Feed the DOWN control line into the upper hole on the rudder 
part of the assembly and tie a knot in the end of the line to keep it 
from pulling through.