O'Brien 2091531 Manual Do Utilizador

Please contact us if you have any questions on the proper selection, function, or safe 

use of this product. 1-800-6-OBRIEN

  Begin by inserting the tube into its cover (when applicable) and aligning it as well as 

possible. When there are multiple air chambers inflate the smaller push-in valve(s) first 

and the large, screw-in (Boston) valve last. To inflate your tube, use any high volume, 

low-pressure inflator. Your O’BRIEN dealer can direct you to the O’BRIEN 12-volt 

inflator or any of the many foot pumps or hand pumps that are available. Some of the 

O’BRIEN inflatables come with large Boston valves that may be filled using either the 

pumps referred to above or your local gas stations air hose. When included, you will 

find it under the top cap of the large screw-in valve.  

 A  towable tube comes with either a “Quick Connect” hook fitting a webbing strap or 

a section of rope at the towing end of the tube. These are for connecting your towline. 

Be sure the line is connected securely. Check it regularly between rides to avoid the 

dangers of a sudden disconnect.

  After use, clean debris from your tube by wiping it off or spraying it with fresh water. 

This is especially important if it has been used in salt water, or in an area where there 

has been exposure to oil or gasoline.

  Never use harsh detergents to clean the tube. If you need more than water, use dish-

washing detergent or a similarly mild cleansing agent.

  Dry your tube and store it DEFLATED, in a cool, dry area. Storage in a very cold 

area could result in cracking of the vinyl tubes. 

  Your tube is made of very durable materials; but you may get an occasional puncture. 

A repair kit is included with your O’BRIEN tube. To patch your tube, take the follow-

ing steps: 

1. Clean the area around the hole to remove any foreign matter. Mild detergent should 

suffice. 

2. Cut a patch (round or oval shaped) from the patching material included in the repair 

kit. The patch must be somewhat larger than the hole.

3. Apply thin layer of glue to the patch and the area around the hole. Allow the glue to 

set on each for about 1 minute.

4. Position the patch over the hole and press down firmly on a flat surface. Remove 

any trapped air by rubbing the patch from the center outward.

5. Wait 24 hours to reinflate your tube.