Cannon Mag 20 Dt/Ts Manual Do Utilizador

5 

Side Rail Mounting 
 

 Side/Rail mounts can be mounted to a 

welded T section. They can also be used at the 
two rail section butt joint. In both installations it is 
recommended to use a non-slip material, such 
as rubber or a thin wood sheet, between metal 
surfaces.  

 

 

You can also use these for mounting to a 

very narrow side gunwale. There is a plate 
provided for back-up with bolts and washers. If 
the gunwale compartment is foamed in, then 
wellnuts should be used. It is also recommended 
to install two additional flat head screws through 
the top plate for stabilization (you will need to 
drill and countersink). 
 
NOTE: In no case should this mount be used on 
fiberglass ¼" thick or less unless it is foamed in. 
  

Pedestal Mounting 
Pedestals are used wherever additional height is 
needed for ease of operation or to clear 
obstructions, such as handrails. 
 
Caution: When using a pedestal mount or 
side/rail mount, do not extend the telescopic 
boom on your Mag 20 DT. The increased 
leverage will cause excessive strain and 
possible failure of the mount. 
 

MOUNT

I

NG & S

E
TUP