Lowrance electronic Fish Finder Manual Do Utilizador

19 

2. The epoxy consists of the epoxy itself and a hardener. Remove the 

two compounds from the package and place them on the paper plate. 

Thoroughly stir the two compounds together until the mixture has a 

uniform color and consistency. Do not mix too fast or bubbles will 

form in the epoxy. After mixing, you have 20 minutes to complete the 

installation before the epoxy becomes unworkable. 

 

Spread a thin layer of epoxy (about 1/16" or 1.5 mm thick) on the face 
of the transducer as shown in the previous figure. Make sure there 
are no air pockets in the epoxy layer! Then, apply the remaining ep-

oxy to the sanded area on the hull. 

3. Press the transducer into the epoxy, twisting and turning it to force 

any air bubbles out from under the transducer face. Stop pressing 

when you bottom out on the hull. When you're finished, the face of 

the transducer should be parallel with the hull, with a minimum 

amount of epoxy between the hull and transducer. 

4. Apply a weight, such as a brick, to hold the transducer in place while 

the epoxy cures. Be careful not to bump the transducer while the ep-

oxy is wet. Leave the weight in place for a minimum of three hours. 

Allow the epoxy to cure for 24 hours before moving the boat. 

5. After the epoxy has cured, route the cable to the sonar unit and it's 

ready to use. 

POWER AND CABLE CONNECTIONS 
The unit works from a 12-volt battery system. For the best results, at-

tach the power cable directly to the battery. You can attach the power 

cable to an accessory or power buss, however you may have problems