Hitachi L200 Manual Do Utilizador

Orientation to Inverter Features

In

v

e

rt

er Mounting

and Installation

Please take a few moments to unpack your new L200 inverter and perform these steps:

1. Look for any damage that may have occurred during shipping.

2. Verify the contents of the box include:

a. One L200 inverter

b. One Instruction Manual

c. One L200 Quick Reference Guide

3. Inspect the specifications label on the side of the inverter. Make sure it matches the 

product part number you ordered.

The L200 Series inverters vary in size according 
to the current output rating and motor size for 
each model number. All feature the same basic 
keypad and connector interface for consistent 
ease of use. The inverter construction has a heat 
sink at the back of the housing. The larger 
models include a fan(s) to enhance heat sink 
performance. The mounting holes are pre-
drilled in the heat sink for your convenience. 
Smaller models have two mounting holes, while 
larger ones have four. Be sure to use all the 
mounting holes provided.

Two chassis GND screws are located on the 
metal tab on the heat sink at the bottom of the 
inverter. Never touch the heat sink during or just 
after operation; it can be very hot.

The electronics housing and front panel are built 
onto the front of the heat sink.

Inverter Keypad - The inverter uses a digital 
operator interface, or keypad. The four-digit 
display can show a variety of performance 
parameters. LEDs indicate whether the display 
units are Hertz or Amperes. Other LEDs 
indicate Power (external), and Run/Stop Mode 
and Program/Monitor Mode status. Membrane 
keys Run and Stop/Reset, and an output 
frequency potentiometer (speed setting knob) 
control motor operation. The FUNC., 

, and 

 keys allow an operator to navigate to the 

inverter’s functions and parameter values. The 
Store key is used when changing a setting.

1

2

RESET

FUNC.

STR

POWER

ALARM

RUN

A

Hz

PRG

5 0.0

1

2