Kenwood TK-5320 Manual Do Utilizador

Note:  To use Priority Scan, a Priority channel must be programmed.

When using a single Priority channel, the transceiver will 

automatically change to the Priority channel when a call is 

received on that channel, even if a call is being received on a 

normal channel.
When using dual Priority channels, Priority channel  is given 

precedence over Priority channel 2.  So, if a call is received on 

Priority channel  while a call is already on Priority channel 2, 

the transceiver will change to Priority channel .

 If the Priority channel has been set as Operator Selectable by 

your dealer, you can reprogram the Priority channels.
1  Select your desired zone and channel.
2  Press the key programmed as Priority-channel Select.
3  Press 

/

 to select “NORMAL”, “PRIORITY ” (   ), 

“PRIORITY 2” (   ), or “PRIORITY &2” (   ).

4  Press 

 to save the setting and exit.

The Scan Revert channel is the channel selected when you 

press the 

PTT switch to transmit during scan.  Your dealer can 

program one of the following types of Scan Revert channels:

• 

Selected:  The last channel selected before scan.

• 

Selected + Talkback:  Same as “Selected”, plus you can 

respond to calls on the channel at which scan is paused.

• 

Priority 1/ Priority 2:  The Priority channel (either Priority  

or Priority 2).

• 

Priority 1 + Talkback/ Priority2 + Talkback:  Same as 

“Priority / Priority 2”, plus you can respond to calls on the 

channel at which scan is paused.

• 

Last Called + Selected:  Same as “Selected + Talkback”, 

plus you can respond on the last channel on which you 

receive a call after scan has resumed.