Kenwood TM-281E Manual Do Utilizador
9
3
GETTING ACQUAINTED
FRONT PANEL
Note:
This section describes only the main functions of the front
panel controls. Explanations for functions not described here are
provided in the appropriate sections of this instruction manual.
provided in the appropriate sections of this instruction manual.
.
;
=
B
>
:
@
q (Power) switch/ Volume control
Press to switch the transceiver power ON or OFF
{page 14}.
{page 14}.
Turn to adjust the level of the receive audio from the
speaker {page 14}.
speaker {page 14}.
w MENU button/ Tuning control
Press to enter MHz Mode {page 16}. In this mode,
you can change the operating frequency in 1 MHz
steps using the
you can change the operating frequency in 1 MHz
steps using the
Tuning
control or Mic
[UP]
/
[DWN]
.
Press and hold for 1 second while in VFO Mode to
begin MHz Scan {page 41} or while in MR Mode to
begin Group Scan {page 42}.
begin MHz Scan {page 41} or while in MR Mode to
begin Group Scan {page 42}.
Press
[F]
then press
[MENU]
to enter Menu Mode
{page 18}.
Turn to select:
• Operating frequencies when in VFO Mode {page 15}.
• Memory Channels when in Memory Recall Mode
• Memory Channels when in Memory Recall Mode
{page 30}.
• Menu Nos. when in Menu Mode {page 18}.
• Scan direction while scanning {pages 27, 39, 47, 49}.
• Scan direction while scanning {pages 27, 39, 47, 49}.
e CALL key
Press to recall the Call Channel {page 35}. Press and
hold for 1 second while in VFO Mode to begin Call/
VFO Scan {page 43}. Press and hold for
1 second while in Memory Recall Mode to begin Call/
Memory Scan {page 43}.
hold for 1 second while in VFO Mode to begin Call/
VFO Scan {page 43}. Press and hold for
1 second while in Memory Recall Mode to begin Call/
Memory Scan {page 43}.
Press
[F]
then press
[CALL]
to activate the Tone {page
24}, CTCSS {page 46}, or DCS {page 48} function.
r VFO key
Press to enter VFO Mode {page 15}. In this mode,
you can change the operating frequency using the
you can change the operating frequency using the
Tuning
control or Mic
[UP]
/
[DWN]
. Press and hold for
1 second while in VFO Mode to begin Band Scan {page
40}. Press and hold for 1 second while in VFO Mode
after programming a scan range to begin Program
Scan {page 40}.
40}. Press and hold for 1 second while in VFO Mode
after programming a scan range to begin Program
Scan {page 40}.