Kenwood TK-5410 Manual Do Utilizador

2

Scan is useful for monitoring signals on the transceiver 

channels.  While scanning, the transceiver checks for a signal 

on each channel and only stops on a channel if a signal is 

present.
To begin scanning, press the key programmed as 

Scan.

•  On K2/K3/K/K/K7 model transceivers, the 

 icon appears on 

the display.

•  The channels included in the scan list are scanned.
•  When a signal is detected on a channel, Scan pauses on that 

channel.  The transceiver will remain on the busy channel until 

the signal is no longer present.  When the signal “drops out”, the 

transceiver will remain on the channel momentarily before Scan 

resumes.  This delay time is programmed by your dealer.  If a 

signal is received during the delay time, the transceiver will remain 

on the same channel.

To stop scanning, press the 

Scan key again.

Note:  In order for Scan to operate, there must be at least 2 

channels added to the scanning sequence.  If there are less 

channels than this, Scan will not operate.

If a key is programmed with the 

Scan Delete function, each 

channel can be locked out of the scan sequence manually.
During scan, you can temporarily remove specific channels 

from the scanning sequence by selecting them and pressing 

the 

Scan Delete key.

•  On K2/K3/K/K/K7 model transceivers, the 

 icon no longer 

appears on the display for that channel.

•  The channel is no longer scanned. However, when scanning is 

ended and restarted, the channels will reset and the channel will 

again be in the scanning sequence.