KitchenAid KGSS907X Ilustrações Dimensionais

®

KGRS807S
KGRS807X
KGSK901S

KGSS907S
KGSS907X

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

The cooktop sides of the slide-in range fit over

the cutout edge of your countertop.
If you have a square finish (flat) countertop and

the opening width is 30" (76.2 cm), no

countertop preparation is required.
Formed front-edged countertops must have

molded edge shaved flat 

³⁄₈" (1.0 cm) from each

front corner of opening.

Tile countertops may need trim cut back 

³⁄₈" 

(1.0 cm) from each front corner and/or rounded

edge flattened.
If countertop opening width is greater than 30"

(76.2 cm), adjust the 

³⁄₈" (1.0 cm) dimension.

Countertop must be level. Place level on

countertop, first side to side; then front to back.

If countertop is not level, range will not be level.

Range must be level for satisfactory baking

conditions.

Use 

³⁄₄" (1.9 cm) rigid pipe gas supply line to

the range location. A smaller size pipe on long
runs may result in insufficient gas supply. With
LP gas, piping or tubing size can be 

¹⁄₂" 

(1.3 cm) minimum. If local codes permit, it is
recommended that new flexible metal tubing,
design-certified by CSA, 4-5 ft (122-152.4 cm)
long, 

¹⁄₂" (1.3 cm) or ³⁄₄" (1.9 cm) I.D., be used

for connecting the range to the rigid gas supply
line. A 

¹⁄₂" (1.3 cm) male pipe thread is needed

for connection to pressure regulator female
pipe threads. An easily accessible individual
manual shutoff valve must be located in the
same room, but external to the range.

120-volt, 60 Hz, AC-only, 15 amp, fused
electrical circuit is required. A separate circuit
is recommended. A time-delay fuse or circuit
breaker is recommended. 

Ref. W10246118C

1/28/11

*Range can be raised approximately 1" (2.5 cm) by adjusting 

the leveling legs.

**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) 

countertop; front of oven door protrudes 1" (2.5 cm) beyond 
24" (61 cm) base cabinet.

*Range can be raised approximately 1"  (2.5 cm) by adjusting 

the leveling legs.

**

A

B

E

D*

C

F**

B*

D

A

E**

C

F

24" (61 cm)

minimum when bottom of

wood or metal cabinet is

covered by not less than 

¹⁄₄"

(0.64 cm) flame retardant

millboard covered with not

less than No. 28 MSG sheet

steel, 0.015" (0.4 mm)

stainless steel, 0.024" 

(0.6 mm) aluminum or

0.020" (0.5 mm) copper. 

30" (76.2 cm) minimum

clearance between the top of

the cooking platform and the

bottom of an uncovered

wood or metal cabinet.

If installing a range hood or

microwave hood combination

above the range, follow the

range hood or microwave

hood combination installation

instructions for dimensional

clearances above the cooktop

surface.