GE JBP27GR Manual Do Utilizador

(continued)

2. 

to

range terminal block.

Splice copper wires to aluminum wiring using

special connectors designed and 

 approved

for joining copper to aluminum, and follow the
connector manufacturer’s recommended
procedure closely.
NOTE: Wire used, location and enclosure of splices,
etc., must conform to good wiring practice 
local codes.

Frame grounded to neutral of appliance
through a link. If used in a MOBILE HOME or
if LOCAL CODES do not permit grounding
through the neutral:

Disconnect the link from neutral.

2. Use grounding terminal or lead to ground
unit in accordance with local codes.
3. Connect neutral terminal or lead to branch
circuit in usual manner.

(If the appliance is to be connected by

means of a cord set, use 4-conductor cord
for this purpose.) 

 

4TH GROUNDING LEAD 

GROUND
LUG

ANTI-TIP bracket is supplied with instructions

for installation in a variety of locations. The
instructions include a template, a parts list and a
list   tools necessary to complete the installation.
Read the IMPORTANT SAFETY INSTRUCTIONS
and the instructions that fit your situation before
beginning installation.

Range must be secured by ANTI-TIP bracket

supplied.
2. See instructions to install (supplied with

bracket).
3. Unless properly installed, range could be
tipped by stepping or sitting on door. Injury

might result from spilled hot liquids or from
range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

range must be level. Leveling feet are locate

at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rotate the
leveling feet in and out as required to level the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, 

the Cleaning Under the Range section in Care

and Cleaning.) On some models, there are 
covers which may be removed for easy
adjustment 

 squeeze and pull).

One of the rear leveling feet will engage the

ANTI-TIP bracket (allow for some side to side

adjustment). Allow a minimum clearance of 
between the range and the leveling foot that is 
be installed into the ANTI-TIP bracket.
Check the range for proper installation into the

ANTI-TIP bracket (after the range has been

properly installed) by grasping the edges of the
REAR burner holes and carefully attempting to
tilt the range forward.

I

Be sure all switches are in the “off” position
before leaving the range.

I