Marvel 6GARMP Manual Do Utilizador

Unit not cold enough

Adjust temperatures (See “Set Tempera-

tures” on page 6)

•  Control set too warm

•  Content temperature not stabilized.

•  Excessive usage or prolonged door 

openings.

•  Airflow to front grille blocked.

 

•  Door gasket not sealing properly.

•  Adjust temperature colder. Allow 24 

hours for temperature to stabilize.

•  Allow temperature to stabilize for at 

least 24 hours.

•  Airflow must not be obstructed to 

front grille. See “clearances” on 

        page 4.

•  Check door alignment and/or replace 

door gasket.

Unit too cold

Adjust temperatures (See “Set Tempera-

tures” on page 6)

•  Control set too cold

•  Door gasket not sealing properly.

•  Adjust temperature warmer. (See 

page 6, “set temperature”). Allow 24 

hours for temperature to stabilize.

•  Check door alignment and/or replace 

door gasket.

No interior light.

•  Failed light bulb

•  Replace light bulb, see page 14.

Light will not go out when door is closed

•  Door not activating light switch.

•  Display light is turned on.

•  Unit not level, level unit, (See page 4, 

“leveling legs”)

•  Verify the door is aligned properly, 

refer to page 9 for instructions.

•  Turn off display light, shut door.

Noise or Vibration

•  Unit not level

•  Level unit, see “Leveling Legs” on 

page 4.

Unit will not run.

•  Unit turned off

•  Power cord not plugged in.

•  No power at outlet.

•  Turn unit on. See “Starting your re-

frigerator” on page 6.

•  Plug in power cord.

•  Check house circuit.

If the unit appears to be malfunctioning, read through this 

manual first. If the problem persists, check the troubleshooting 

guide below. Locate the problem in the guide and refer to the 

cause and its remedy before calling for service. The problem may 

be something very simple that can be solved without a service 

call. However, it may be required to contact your dealer or a 

qualified service technician.

- Never attempt to repair or perform 

maintenance on the unit until the main electrical power has 

been disconnected. Turning the units control “off” does not 

remove electrical power from the units wiring.

15