Marvel 6GARM Manual Do Utilizador

14

Disconnect the power cord before cleaning the condenser.

The tube and wire condenser underneath the cabinet does 

not require frequent cleaning; however, satisfactory cooling 

depends on adequate ventilation over this heat exchanger. It is 

recommended to annually clean the condenser by brushing and 

vacuuming. Access the condenser, from the front of the unit by 

removing the toe grille. (See Figure 18). Remove the 2 screws 

holding the toe grille in place with a phillips screwdriver. The 

condenser is located 2-1/2” (6.4cm) behind the toe grille on the 

left side of the cabinet. We recommend using a refrigerator coil 

cleaning brush to loosen the dust and dirt, then vacuuming.

Be sure that nothing obstructs the required air flow openings in 

front of the cabinet.  (See page 4).

The painted cabinet can be washed with mild soap and water 

and thoroughly rinsed with clear water.  NEVER use abrasive 

scouring cleaners.

Wash interior compartment with mild soap and water.  Do NOT 

use an abrasive cleaner, solvent, polish cleaner or undiluted 

detergent.

The shelves may be cleaned with mild soap and water and a 

soft cloth.  Do NOT use any abrasive cleaners. The glass may be 

removed for easier cleaning.

Use a glass cleaner or mild soap and water and soft cloth to 

clean the glass door model.  Do NOT use any abrasive cleaners.

The vinyl gasket may be cleaned with mild soap and water, a bak-

ing soda solution or a mild scouring powder.

 DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT 

BULB REPLACEMENT.  Failure to do so may result in an electrical 

shock that could severely injure you.

The 6GARM uses one, 15 watt incandescent light bulb to il-

luminate the interior of the refrigerator.  The light bulb is a 

very reliable electrical component, but should it not function 

properly, please call the dealer where you purchased your 

refrigerator for a replacement light bulb.  Use only an origi-

nal equipment light bulb from your dealer or AGA MARVEL.

Do NOT under any circumstance use a light bulb that exceeds 15 
watts!

To replace the light bulb, disconnect power to the unit.  Unscrew 

the old light bulb located behind the display housing at the top 

of the unit.  Set the old light bulb aside.  Screw the new light 

bulb into place.  Reconnect power to the unit. Check to see if the 

light bulb operates properly to complete the installation.

The light bulb is not covered by your warranty.  A replacement 

bulb can be obtained from your dealer or from AGA MARVEL.

If a power failure occurs, try to correct it as soon as possible.  

Minimize the number of door openings while the power is off so 

as not to adversely affect the unit’s temperature.  

Toe grille screw

Condenser is 

behind toe grille 

on left side of 

cabinet

Toe grille (Front Grille)

Figure 18