Hoshizaki 73183 Manual Do Utilizador

B. Important Notes for Component Replacement

CAUTION

When replacing a component listed below, see the notes to help ensure proper
operation.

Component

Notes

Compressor

Install a new start relay, start capacitor, and compressor overload (compressor overload
is integrated with the start relay on refrigerators; internal on 1-section freezers; external on
2-section freezers).

Compressor,
Evaporator
Fan Motor,
Condenser Fan
Motor

WARNING! To reduce the risk of electric shock, be sure to reconnect the
component's ground wire.

Expansion Valve • Attach the expansion valve bulb to the suction line in the same location as the previous

bulb.

• Secure the bulb with the clamp and holder, then insulate it.

Defrost
Thermistor

After working with or around the defrost thermistor on a freezer, make sure the defrost
thermistor wire is not touching the defrost heater.

Control Module

If three dashes (- - -) appear on the display module when energized, the compressor and
display module are off. To turn the compressor and display module on, press and hold
the upper and lower buttons until the temperature appears on the display.

CAUTION! The

three dashes must be cleared, otherwise the compressor will not run and product
will be lost.

C. Door Re-Hinging

This unit is provided with a cabinet design which, after being delivered to the installation
location, permits changing of the door swing from left to right or right to left. To change
the door swing, an HS kit from your local Hoshizaki distributor is required. See the table
below.

CAUTION! Improper installation of the HS kit may result in the doors not

closing completely and/or the gaskets not sealing correctly. For further details,
contact your local Hoshizaki distributor or Hoshizaki Technical Support at
1-800-233-1940.

Convert

HS Kit Number

Right Hinge to Left Hinge

HS-3725

Left Hinge to Right Hinge

HS-3726