Hoshizaki KML-250MAH Manual Do Utilizador

21

1/2" Female Pipe 
Thread (FPT)

1/4" Nominal ID Copper 
Water Tubing or Equivalent

3/8" Female Pipe 
Thread (FPT)

1/4" Nominal ID Copper 
Water Tubing or Equivalent

• Shut-off valves and drain valves must be installed at both the condenser water supply inlet 

and condenser return outlet.

• Minimum water flow to the condenser is 4 GPM. 
• The pressure differential between the condenser water supply inlet and condenser return 

outlet must be no less than 10 PSIG.

• When using a glycol blend, the solution mixture should be less than 30% glycol.
• In order to maintain the proper high side pressure, the condenser water supply inlet 

temperature should not drop below 45°F (7°C) and the condenser return outlet 
temperature must be in the 104°F to 115°F (40°C to 46°C) range. Once the icemaker 
installation is complete, confirm the condenser return outlet temperature 5 minutes after a 
freeze cycle starts. If the condenser return outlet temperature is not in the proper range, 
use a flat blade screwdriver to rotate the adjustment screw on the water-regulating valve 
until the temperature is in the proper range (rotate counterclockwise to raise temperature 
or clockwise to lower temperature).

Icemaker

Icemaker Water 

Supply Inlet

1/2" FPT

Bin Drain Outlet

3/4" FPT

2-inch (5-cm) air gap

Floor Drain

Icemaker

Drain Outlet 

3/4" FPT

Vent Tube

Vent Tube

Condenser Water 

Supply Inlet

1/2" FPT

Condenser 

Return Outlet 

3/8" FPT

Shut-Off Valve

Minimum 1/4" Nominal ID Copper 

Water Tubing or Equivalent

Drain Valve

Ice 

Storage 

Bin

Minimum 3/4" Nominal ID 

Hard Pipe or Equivalent

Separate piping to approved 

drain. Leave a 2-inch (5-cm) 

vertical air gap between the 

end of each pipe and the 

drain.

Be sure there is sufficient 

extra water supply line and 

drain line for the appliance 

to be pulled out for service.