Hoshizaki MWH KML-631MAH Manual Do Utilizador

12

• The appliance must be installed in accordance with applicable national, state, and 

local codes and regulations.

• Failure to install, operate, and maintain the appliance in accordance with this 

manual will adversely affect safety, performance, component life, and warranty 
coverage and may result in costly water damage.

• 

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews 

are securely in place after installation. Make sure that none have fallen into the 
dispenser unit/ice storage bin.

• The icemaker is not intended for outdoor use. Normal operating ambient 

temperature must be within 45°F to 100°F (7°C to 38°C); Normal operating 
water temperature must be within 45°F to 90°F (7°C to 32°C). Operation of the 
icemaker, for extended periods, outside of these normal temperature ranges may 
affect icemaker performance.

• The icemaker will not work at sub-freezing temperatures. To prevent damage 

to the water supply line, drain the icemaker if the air temperature is going to go 
below 32°F (0°C). See "IV. Preparing the Icemaker for Periods of Non-Use."

• The icemaker should not be located next to ovens, grills, or other high heat producing 

equipment.

• Allow 6" (15 cm) clearance at rear, sides, and top for proper air circulation and ease of 

maintenance and/or service should they be required.

• The location should provide a firm and level foundation for the appliance.

• Visually inspect the exterior of the shipping container and immediately report any 

damage to the carrier. Upon opening the container, any concealed damage should also 
be immediately reported to the carrier.

• Remove the shipping carton, tape, and packing material. If any are left in the appliance, 

it will not work properly.

• See the nameplate on the rear panel, and check that your voltage supplied corresponds 

with the voltage specified on the nameplate.

• Remove the panels to prevent damage when installing the appliance. See "II.C. How to 

Remove Panels."

• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the appliance is exposed to the 

sun or to heat, remove the film after the appliance cools.