Avanti WD362BP Manual Do Utilizador

 

•  Wash the inside of the reservoir with a warm water and baking soda solution. The solution should 

be about 2 tablespoons of baking soda to a quart of water. 

•  The drip tray and water faucets should be cleaned with mild detergent and warm water. 
•  At regular intervals or once a month inspect the coils located across the back of the dispenser. 

Vacuum accumulation of dust or clean it with a hard brush. 

 

•  If the water dispenser will not be used for a long period of time, unplug the power cord from the 

wall outlet. 

•  Drain the water through the faucets. 
•  Turn the switch market hot to the “OFF” position. 
•  Drain the water from the tank by removing the plug from the back of the dispenser. 
 
 
 
 

 

Unit should not be transported on the sides. Place it upright if possible and cover it with a blanket.

 

You can solve many common water dispenser problems easily, saving you the cost 
of a possible service call. Try the suggestions outlined below to see if you can solve 
the problem before calling the service. 

Water dispenser does not operate. 

Not plugged in. 
The circuit breaker tripped or a blown fuse. 

Water cooler is not cold enough. 

Check to be sure the cold switch on the back is ON. 
The water dispenser does not have the correct 
clearances. 

Water dispenser hot water is not hot enough. 

Check to be sure the hot switch on the back is ON. 

Compressor turns on and off frequently. 

The room temperature is hotter than normal. 
The temperature control is not set correctly. 
The water dispenser does not have the correct 
clearances. 

Vibrations. 

Check to assure that the water dispenser is level. 

The water dispenser seems to make too much 
noise. 

The rattling noise may come from the flow of the 
refrigerant, which is normal. 
As each cycle ends, you may hear gurgling sounds 
caused by the flow of refrigerant in your water dispenser. 
Contraction and expansion of the inside walls may 
cause popping and crackling noises. 
The water dispenser is not level. 

Bottle feels warm. 

The water system is overfilled. Dispense Cold water until 
air is released into the bottle. 

Water bottle is hot. 

Water is boiling in the hot tank and bubbling up into the 
bottle. Press the hot dispenser button until water flows to 
remove air from the hot tank.