Invacare 98070 Manual Do Utilizador

1. Position transfer bench upside down on a level surface.

2. Remove the four (4) mounting 

screws that secure the seat to the leg 
frames.

3. Position backrest onto the leg 

frames.

4. Install one (1) mounting screw 

through back support tube, leg 
frame, and into seat. Repeat for 
three (3) remaining mounting 
screws.

5. Securely tighten all hardware until 

a resistance is felt and all slack is 
removed.

1. Select one (1) of the nine (9) adjustment holes located on the lower leg frame.

2. Depress the snap button and slide 

the leg extension up or down to the 
desired height until snap button 
protrudes fully through the 
adjustment hole of the leg 
extension.

3. Repeat for the other legs.

4. Make sure all four (4) legs are 

adjusted so that the transfer bench 
sits level inside and outside of the 
tub.

1. Use a mild soap or non-abrasive cleanser and water to clean the transfer bench.