Manitowoc Ice K00141 Folheto

1.  The K00141 kit is used for installing a Q-0320, Q-0420, and 22" S-series ice machines on a Manitowoc S-series 30” 

(76 cm.) wide bin or Q-series 30” (76 cm.) wide Manitowoc dispenser or bin. 

2.  Installation (bin or dispenser must be level before starting): 

A.  Remove existing foam tape from top of bin or dispenser.  When installing a K00141 on a Manitowoc dispenser, 

remove the gray side trim pieces on the top sides of the dispenser. 

B.  Place support angle on bin or dispenser, as shown, prior to adapter installation.  Locate foam tape from kit in the 

(A) positions on top of bin, as shown.  Note locations of narrow and wide tape. 

C.  Place adapters on bin or dispenser, as shown.  Make sure the two holes from the support angle and adapters are 

aligned on the side. 

D.  Using the adapters as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in bin or 

dispenser.  Warning:  Do not drill through interior liner.  Attach with 10-24 x .500” screws provided. 

E.  Apply foam tape to the edge of the adapters and on the front and back of the bin or dispenser between the adapters 

in the (B) positions.  Note:  It is recommended to RTV intersections and along front inside edge of foam tape (see 
drawing) to prevent water tracking. 

3.  Refer to ice machine installation manual for ice machine installation procedures. 
 

Manitowoc Ice, Inc. 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879                                                 8011123                   
Web Site - www.manitowocice.com                                                                                                                                                       Rev. 05/12/04 

ICE 

BIN 

BIN 

(A) Locate Narrow Foam 
       Tape Between Bin and 
       Adapters 
 
                    Adapters 

Adapter 

(B) Wide Foam Tape 
       (from Kit) 

to Prevent Water Tracking 

Support Angle 

(A) Wide Foam Tape, 
        Two Places, Approx. 2”

(B) Wide Foam Tape 

(A)