Kelvinator COMMERCIAL FREEZER/REFRIGERATOR GLASS DOOR REFRIGERATOR Manual Do Utilizador

4

• Put two (2) carriage bolts through the rear (non-brake) side of

the fixed caster and hold the carriage bolts loosely in place by
threading several turns on each of the locking nuts. Do not
tighten the bolts yet.

• Hold the caster in position, insert the carriage bolt heads into

slots A & B near the front of the caster rail and slide the caster
back.

• Insert the two (2) front carriage bolts thru the top side of the

caster rail and then thru the front holes on the caster. Attach
locking nuts to each.

• Tighten all locking nuts securely using a 1/2 inch wrench (see

Fig. 4).

• Repeat the same procedure for the other fixed caster.

FIXED CASTER 

LOCKING NUTS 

CARRIAGE BOLTS 

BRAKE 

 

FRONT OF 

CASTER RAIL 

 

CARRIAGE 

BOLTS 

SLOTS A&B 

Figure 4 

• Place a washer onto one of the four long bolts and slide bolt

through the hole located just behind the fixed caster at the
front of caster rail.

• Align the caster rail assembly with the right hand side of the

unit. Make sure the fixed caster is positioned toward the front
of the unit.

• Align the bolt with the threaded hole in the front right foot pad

of the unit. Thread the bolt into the hole until finger tight (see
Fig. 5).

Figure 5 

WASHER 

WASHER 

BOLT 

BOLT 

• Place a washer on one of the four long bolts and then feed the

bolt through the hole in one of the swivel casters (see Fig. 6).

• Next, insert that same caster bolt through the hole on the metal

spacer plate and then thru the rear hole of the caster rail (see
Fig. 7).

• Thread the caster bolt into the hole in the bottom-most foot

pad on the unit.

• Tighten both top and bottom bolts securely using a 1/2 inch

fixed or socket wrench.

• Repeat the same procedure on the left hand side. After

installation, carefully tip the unit up with the help of an assistant.

Swivel
Caster

Washer

Bolt

 

SPACER 

PLATE 

Figure 7 

Figure 6

Figure 3 

DOOR 
SUPPORT 
BRACKET 

• Remove bottom door support bracket and screw opposite the

door hinge using a 3/8" socket wrench (see Fig. 3).