DeLonghi BAR 32 Manual Do Utilizador

7

The following terms are used throughout the instruction
manual
1

Filter holder for ground coffee

2 Filter for coffee powder with creamer
3 Filter for pods (if fitted)
4

Filter holder for pods (if fitted)

Steam release knob

Coffee tamper

Black area inside for positioning cups

Power supply cable

OK’ light (coffee/water or steam)

‘ON/OFF’ light        

Selector knob

Espresso function

“O” OFF position

Steam position

Coffee measuring spoon

Boiler outlet

Delivery tube

Cappuccino function (for milk frothing)

Water tank

Lid for water tank

• This machine has been built to “make coffee” and to

“reheat beverages”; please be careful to avoid burns
from the sprays of hot water or steam and avoid any
improper use.

• When the appliance is in use, do not touch any of the

machine’s hot surfaces

• After unpacking, make sure that the machine is

complete and undamaged. In case of doubt, do not
use the appliance and seek the advice of a qualified
service professional.

• Packaging materials (plastic bags, foam polystyrene,

etc.) should not be left within the reach of children as
this could be a potential source of danger.

• This appliance is to be utilized for domestic use only.

Any other use is to be considered improper and 
therefore, dangerous.

• The manufacturer takes no responsibility for damage

derived from improper use.

• Never touch the appliance with wet or damp hands
• The appliance is not intended for use by young

children or infirm persons without supervision.

• Your children should be supervised to ensure that

they do not play with the appliance.

• In case of breakdown or malfunctioning, turn off the

appliance immediately and do not touch it. For
repairs, please contact a Service Centre authorized
by the manufacturer and request the use of original
replacement parts only.  The lack of respect for this
point may compromise the safe use of the appliance.

• The power supply cable of this appliance must never be

replaced by the user, because its replacement requires
the use of special tools.  If the cable should become
damaged, or in case it needs to be replaced, please go
to a Service Centre authorized by the manufacturer.

• Place the coffee maker on flat work surface at a safe

distance from taps and sinks.

• Check that the voltage corresponds to that indicated on

the appliance rating plate. The appliance must always
be connected to a well-earthed socket rated at 10 A
minimum. The manufacturer is not liable for  damage
caused by inadequate earthing of the appliance.

• In the event of incompatibility between the plug on

the appliance and the socket, have the plug replaced
with another of the right type by a qualified
professional.

• Never install the machine in an environment that can

reach a temperature less than or equal to 0°C (if the
water in it freezes, the coffee maker may be
damaged).

• When the machine is in operation, any additional

cable can be stored in the machine by inserting it
back into the cable supply outlet.

• The power cable can be positioned to the right or

left, depending on where the nearest power outlet to
the appliance is located, by lodging it in the
corresponding guides underneath the appliance
(Fig. 1).

• When changing the position of the power cable,

check that it is properly secured by the special clips
underneath the appliance (Fig. 1).

FILLING THE WATER TANK:
To remove the water tank lid (fig.2) simply pull upwards
(fig 3) and fill the tank at the sink (fig 4).  Do not exceed
the MAX level on the water tank.  The tank may also be
filled without removing it, simply by pouring water into
it directly from a jug.
Replace the tank by connecting the valve at the bottom
of the tank with the hole in the base on the machine.

EC190/200 GB  2-01-2003  10:24  Pagina 7