Sony KDL-37XBR6 Manual Do Utilizador

Use the supplied screws to attach the TV unit 
to the Table-Top Stand. Shown here with a 
three screw model; other models may require 
screwing four screws (refer to the “Attaching 
the Table-Top Stand” flyer).

All models are ready to be mounted on a wall. 
Models KDL-52V4100 and KDL-52W4100 will 
require detaching the Table-Top stand.

• Sufficient expertise is required in installing this 

TV, especially to determine the strength of the 
wall for withstanding the TV’s weight.

• Be sure to use the screws supplied with the 

Wall-Mount Bracket when attaching the 
mounting hooks to the TV set.
The supplied M6 screws are designed so that they 
are 8 mm to 12 mm in length when measured 
from the attaching surface of the mounting hook.
The diameter and length of the screws differ 
depending on the Wall-Mount Bracket model. 
Use of screws other than those supplied may 
result in internal damage to the TV set or cause it 
to fall, etc.

• Do not remove the Table-Top Stand of the 

KDL-52V4100 and KDL-52W4100 for any 
reason other than to wall-mount the TV.

• Models KDL-32/37XBR6, KDL-40V4150, 

KDL-40/42/46V4100, KDL-40/46W4100 and 
KDL-46W4150 can be wall-mounted as 
packaged. If you decided to use the TV with the 
TV stand and later want to wall-mount the TV, 
follow the steps provided on this page to remove 
the Table-Top Stand.

• Be sure to store the unused screws and Table-Top 

Stand in a safe place until you are ready to attach 
the Table-Top Stand. Keep the screws away from 
small children.

For details on how to use the Wall-Mount Bracket
compatible with your model, visit
www.sony.com/accessories
Or call  1-800-488-7669 (for United States)

1-877-899-7669 (for Canada)

Follow the simple steps below to remove the 
Table-Top Stand:

Unplug the AC power cord and disconnect all 
the cables from the TV.

Secure the Mounting Hook to the rear of the 
TV. 

Adjust the angle of the Mounting Hook. 

Remove the screws on the rear of the TV (see 
illustration in the next column). Do not 
remove any other screws from the TV.

When screws are removed, lift the TV off the 
stand. Make sure that you carry out this task 
with at least two or three people. Do not 
attempt to lift the TV by yourself.

• Shown here is model KDL-52V4100; other 

models may only require removal of three screws 
(refer to the “Attaching the Table-Top Stand” 
flyer).

If an electric 
screwdriver is used, set 
the torque to tighten at 
approximately 1.5 N·m, 
15 Kgf·cm.

M6 Screw (supplied with the Wall-Mount 
Bracket)

Mounting Hook

Rear of the TV set

8-12 mm