Bushnell 98037 Manual Do Utilizador

Page 2

applicators is approximately 400ºF (200ºC).  Protective gloves should always be 
worn.  Careless handling can cause skin burns. If molten adhesive comes into 
contact with the skin immerse the affected area immediately in plenty of cold water.
Seek medical advice if necessary.
In addition to the safety instructions herein, any statutory regulations, local fire
insurance regulations, or other generally valid “regulations for accident prevention” 
must be complied with when using this tool. 

•  Never use the tool if it is damaged in any way.

•  Do not use this tool in damp rooms, outdoors while it is raining, or where there is 

high humidity.

•  Do not use this tool in the vicinity of any heat-sensitive materials, or any flammable 

materials, liquids, or gases.

•  Only use extension cables that meet the specification shown in “Technical data”.

•  Never pull on the tool’s connecting cable.

Pneumatically-driven Hot Melt Cartridge Spray Dispenser, fitted with 356°F (180°C) 

thermostat (suitable for standard spray hotmelt adhesives)

Valve body airline adaptor
Plastic Stand
Manual

Pneumatically-driven Hot Melt Cartridge Spray Dispenser, fitted with 383°F (195°C) 

thermostat (suitable for polyamide spray hotmelt adhesives)

Valve body airline adaptor
Plastic Stand
Manual

The Loctite

®

 Hysol

®

 175-SPRAY and 175-SPRAY-HT are the highest output, hand-

held industrial spray hotmelt applicators available. With its two powerful 250W
stainless steel cartridge heaters, they are capable of dispensing up to 9 lbs. of molten 
hotmelt per hour, yet only take 10 minutes to warm up from cold. 

Supported by a range of spray adhesive formulations, the Loctite

®

 Hysol

®

 175-SPRAY

and 175-SPRAY-HT are suitable for most applications  - they can even be used with 
heat sensitive substrates such as expanded polystyrene and other plastic foams.
Also, the Loctite

®

 Hysol

®

 175-SPRAY and 175-SPRAY-HT system are solvent-free and 

non-toxic, so there are none of the environmental problems often associated with other 
spray adhesive applicators.

Designed to comply with world wide safety standards, the Loctite

®

 Hysol

®

 175-SPRAY

and 175-SPRAY-HT also feature a totally enclosed heater housing, and are fitted with 
thermal fuse protection.