Husqvarna MC1809H Manual Do Utilizador
12
FIGURE 2
2A.
BLADE SHAFT NUT: Use to tighten the outer flange
against the diamond blade.
2B.
OUTER FLANGE: Use to hold the diamond blade in
position.
2C.
NOT USED
2D.
LOCKING PIN: Use to prevent the diamond blade
from rotating on the shaft during operation.
2E.
DIAMOND BLADE: Use as the cutting tool for
concrete and asphalt surfaces.
2F.
INNER FLANGE: Inside support used to hold the dia-
mond blade in position.
2G.
NOT USED
2H.
BLADE GUARD FRONT: The front section of the
blade guard.
2I.
BLADE SHAFT: Supports the blade flanges and blade.
2D
2E
2H
2B
2 I
2F
2A
FIGURE 1
1A.
WATER VALVE: Use to control the water supply to
the diamond blade.
1B.
WATER INLET: Connect water hose at this garden
hose connection.
1C.
HANDLE ADJUSTMENT KNOBS: Use to adjust
handle height.
1D.
ENGINE STOP SWITCH: Stop Switch: Push down
to stop engine.
1E.
DEPTH CONTROL LOCK: Use to lock the position
of the Depth Control Hand Wheel.
1F.
DEPTH CONTROL HAND WHEEL: Controls
lowering and raising of the blade into and out of the