Pressure Systems 9816 Manual Do Utilizador
Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©
Page 122
www.PressureSystems.com
Figure 5.9
Schematic of 9816 Solenoids
(4)
If the either the new or old solenoid does not have a pluggable wiring harness at the
solenoid, the new solenoid wires will require crimp pins to be installed for insertion in the
P5 mating housing. The proper crimp pin is Molex part number 08-56-0110. After
installing the crimp pins to the solenoid wiring, remove the old crimp pins from the Molex
P5 housing and insert the new solenoid’s wiring. Ensure that the new wires are installed
in the same position as the old wires.
solenoid, the new solenoid wires will require crimp pins to be installed for insertion in the
P5 mating housing. The proper crimp pin is Molex part number 08-56-0110. After
installing the crimp pins to the solenoid wiring, remove the old crimp pins from the Molex
P5 housing and insert the new solenoid’s wiring. Ensure that the new wires are installed
in the same position as the old wires.
Figure 5.9a
Solenoids Attached to Module