Pressure Systems 9046 Manual Do Utilizador
Pressure Systems, Inc. Model 9046 User’s Manual
Page 10
www.PressureSystems.com
2.4 IP Address Assignment
The module IP address assignment can only be changed if your computer is able to
communicate with the module:
communicate with the module:
1.
Use the PSI program NUSS to determine the current module IP address. Change the
module IP address to one compatible with your system host computer. Depending on your
operating system, it may be necessary to change your Host IP Address temporarily to
allow connection to the module.
module IP address to one compatible with your system host computer. Depending on your
operating system, it may be necessary to change your Host IP Address temporarily to
allow connection to the module.
2.
Upon completion of addressing, change the Host computer IP address back to its previous
value, and verify that the Host can connect to the Model 9046 module using NUSS.
value, and verify that the Host can connect to the Model 9046 module using NUSS.
The module and PC are now ready to communicate. Follow this procedure to assign an IP
address:
address:
1.
From the start menu select NUSS. The Network Status Screen should appear. Note that a
"Querying Network" message briefly appears, then the Nodes On Network Box will display
the node map (the types of modules connected and the serial number of each module).
"Querying Network" message briefly appears, then the Nodes On Network Box will display
the node map (the types of modules connected and the serial number of each module).
Figure 2-4: Network Status Screen
2.
Note the IP address. The serial number should match the label on the unit. If the module
in question is a new unit, the IP address should be the factory default.
in question is a new unit, the IP address should be the factory default.