Tripp Lite TLP606DMUSB Manual Do Utilizador

2

SAVE THESE INSTRUCTIONS

CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords or 

adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor away 
from heat-emitting appliances such as radiators or heat registers. Do not install where excessive 

moisture is present. Do not plug extension cords into it. Never install electrical, telephone, network 

or coaxial wiring during a lightning storm. Do not drill into any part of the housing or open the 

housing for any reason. There are no user-serviceable parts inside.

Important Safety Instructions

•  Use of this equipment in life support applications where failure of this equipment can reasonably 

be expected to cause the failure of the life support equipment or to significantly affect its safety 

or  effectiveness  is  not  recommended.  Do  not  use  this  equipment  in  the  presence  of  a 
flammable anesthetic mixture with air, oxygen or nitrous oxide.

Installation

(Optional Installation, TLP606USB Only): If desired, mount your surge suppressor on a wall 

or other sturdy, vertical surface. However, you must mount the surge suppressor prior to 

connecting your equipment. Place a sheet of paper over the surge suppressor’s mounting holes 

and mark their centers with a push pin. Next, place this template over the desired area and mark 

with the push pins. Install screws (user supplied) into the marks until ¼ in. (0.6 cm) of the screw 

heads are exposed. Mount the surge suppressor over the screw heads and slide into place.
(Installation,  TLP606DMUSB 

Only): This suppressor features a 

built-in clamping system for 

attaching the unit to desks, 

tables and work benches. To 

install, loosen the two mounting 

clamps, then slide the suppressor 

firmly onto the edge of an 

appropriate surface. Retighten 

the mounting clamps.

the  AC  Power  Line:  Plug the surge 

suppressor’s  power  cord  into  a 

standard, 3-wire grounded 120V AC 

outlet.
Turn  Your  Surge  Suppressor  ON: 

Press  the  surge  suppressor’s  power 

switch to “ON” or “RESET” (depending 

on model). Select models feature an 

illuminated switch.

13-05-274  93-32C0-EN.indd   2

6/14/2013   9:50:49 AM